Injection Needle Sizes: IM, SC and Intradermal (20G–29G)

news

Injection Needle Sizes: IM, SC and Intradermal (20G–29G)

A needle size is never one number. Two numbers decide whether an injection reaches the tissue it was prescribed for: the gauge, which sets the bore, and the length, which sets the depth. Route comes first — intramuscular, subcutaneous or intradermal — and then age, weight and injection site adjust both numbers.

This page gives the numbers per route and per site, the ISO 6009 hub color that should be on each size from 20G to 29G, and the specification items to settle before a purchase order. Teamstand supplies single-use hypodermic needles across that full range, and safety syringes, from 100,000 pieces per order.

The clinical figures below come from CDC and provincial health-authority guidance. They describe what the needle has to do; they do not replace the drug label or your facility protocol.

hypodermic needle (16)

Gauge Is a Diameter, Not a Ranking

Higher gauge means thinner needle. A 20G needle measures 0.9 mm outside diameter; a 29G needle measures 0.33 mm. ISO 6009 calls the millimetre figure the designated metric size and treats gauge as a legacy label — both names describe the same tube, so a specification that carries only the gauge is one conversion away from an error.

Hub color is the third piece of the same information. It exists for rapid visual identification, and the standard is explicit that the color does not relieve the user of checking the size marked on the needle and its packaging.

Gauge Outer diameter ISO 6009 hub color Where it usually sits in an injection program
20G 0.9 mm Yellow Viscous or depot medication, filling from a vial
21G 0.8 mm Green Viscous IM, some blood collection
22G 0.7 mm Black Standard adult IM
23G 0.6 mm Blue IM for smaller adults and adolescents, SC
24G 0.55 mm Medium purple Thin IM, SC
25G 0.5 mm Orange SC, thin IM
26G 0.45 mm Brown SC, intradermal
27G 0.4 mm Medium grey Intradermal, fine SC
28G 0.36 mm Blue-green Fine SC, pediatric
29G 0.33 mm Red Fine SC, insulin syringes

Colors follow ISO 6009 as listed in FDA 510(k) K222271, which records 21G as light green, 23G as light blue and 28G as blue-green. The same list assigns yellow to both 20G and 30G, which is one more reason to print the gauge, not only the color, on the carton.

The Length Decision Comes After the Route

The route fixes the tissue depth, and the patient fixes how far that tissue sits below the skin. Four lengths cover almost every case that CDC guidance describes: 16 mm (5/8 inch), 25 mm (1 inch), 32 mm (1-1/4 inch) and 38 mm (1-1/2 inch).

Route Gauge Length Angle Typical site
Intramuscular (IM) 22–25G; 20–21G for viscous drugs 16–38 mm, by age and weight 90° Deltoid, vastus lateralis, ventrogluteal
Subcutaneous (SC) 23–25G 16 mm 45°, or 90° with a short needle and skin stretched Upper outer triceps, thigh
Intradermal (ID) 26–27G, short bevel 6–13 mm 5–15°, bevel up Volar forearm

The gauge column is narrow because the tissue does not change much between patients; the length column is wide because body composition does.

Intramuscular: Gauge Stays Narrow, Length Changes With the Patient

CDC guidance holds the IM gauge at 22–25G for every age group and moves only the length. For adults 19 and older the length is set by sex and weight:

Patient Needle length Site
60 kg (130 lb) or less 25 mm (1 inch) Deltoid
60–70 kg (130–152 lb) 25 mm (1 inch) Deltoid
Men 70–118 kg, women 70–90 kg 25–38 mm (1–1.5 inch) Deltoid
Men over 118 kg, women over 90 kg 38 mm (1.5 inch) Deltoid

For a patient at or below 60 kg, the CDC table allows 25 mm, and its footnote allows 16 mm if the skin is stretched tight and the subcutaneous tissue is not bunched.

Below 19 the site changes as well as the length. Neonates up to 28 days take 22–25G at 16 mm into the vastus lateralis, and infants up to 12 months take 25 mm into the same muscle. From toddler age the choice splits between the deltoid and the thigh: 1–2 years take 25–32 mm in the vastus lateralis or 16–25 mm in the deltoid; 3–10 years take 16–25 mm in the deltoid or 25–32 mm in the vastus lateralis; 11–18 years take 16–25 mm in the deltoid. Most adolescents and adults need 25–38 mm to be sure the dose is in muscle rather than in fat.

Two adjustments sit outside the gauge table. Viscous products — immunoglobulins, depot antipsychotics, some hormonal preparations — need a wider bore, 22G or larger, because the fluid has to pass; the same source notes that a 25G IM injection should be given slowly, over about five seconds, to limit pain and muscle trauma. And a shorter needle is not automatically safer for a thin patient: at 16 mm the skin has to be stretched flat and the subcutaneous tissue must not be bunched, or the dose lands short of the muscle.

The IM Site Changes the Length and the Volume

Site selection is a clinical decision, but it determines what you have to stock. The three sites still in routine use differ in depth, in how much volume they accept, and in how much they depend on patient position.

Site Who it suits Length Volume the site accepts
Deltoid Adults and children over 1 year, vaccines and low-volume drugs 16–38 mm by weight Small volumes; confirm the limit on the drug label
Ventrogluteal Adults, and children over 7 months for larger or viscous volumes 16 mm up to age 5; 25–34 mm from age 6 1.5 mL up to 5 years, 2.5 mL at 6–15 years, 5 mL from 15 years
Vastus lateralis Neonates and infants; adults with no other access 16 mm at birth, 25–32 mm after the first year Set by the drug label
Dorsogluteal Avoid — Not recommended in children because of the risk of damage to the sciatic nerve and gluteal artery

The ventrogluteal figures come from a provincial drug-information guideline that also specifies 22G for all three age bands. That is the pattern to notice: the site with the largest volume ceiling is also the one where a mid-range gauge is standard, because the muscle is deep and well separated from nerves and vessels.

Subcutaneous: The Most Forgiving Route, and the Easiest to Get Wrong

CDC gives one SC specification for all ages: 23–25G, 16 mm, into the fatty tissue over the triceps from 12 months up, or the thigh for infants under 12 months. Nothing in the length changes with weight, because the target layer is just under the skin.

What changes is technique. A 45° insertion with a lifted skin fold is the default; a 90° insertion is acceptable with a short needle when the skin is stretched tight and the tissue is not bunched. Getting that wrong is how a subcutaneous dose becomes an intramuscular one.

Insulin is the case where the general rule is replaced. Injection-technique guidance for insulin and GLP-1 therapy names a 4 mm pen needle as first choice for adults regardless of body mass index. Lengths of 4, 5 and 6 mm are all suitable across BMI bands; anything 8 mm or longer requires a lifted skin fold or a 45° angle. A 29G hypodermic needle is the finest size in the Teamstand range and fits insulin syringes at their shorter lengths. Pen needles are a separate product category with their own standards, and ISO 6009 does not apply to them — so a hub color chart cannot be used to identify a pen needle.

Intradermal: Small Volume, Short Bevel, Shallow Angle

The intradermal route is the one where needle geometry matters more than gauge. For a Mantoux tuberculin skin test, CDC specifies a single-dose tuberculin syringe with a 6–13 mm (1/4 to 1/2 inch), 27G needle with a short bevel; Los Angeles County's TB protocol lists 26G or 27G for the same step. Both sizes sit inside the 20G–29G range.

The rest of the technique is what makes the test readable: 0.1 mL of tuberculin, needle inserted bevel up at 5–15°, and a tense pale wheal of 6–10 mm that should appear over the needle tip. If no wheal forms, or fluid leaks out, the test is repeated at least 5 cm from the first site. A long-bevel needle at this angle cuts deeper than intended and produces a wheal that cannot be measured consistently — which is why intradermal needles are specified by bevel type as well as by gauge.

Why 20G and 29G Both Belong in One Range

Read as a whole, 20G–29G is not a catalog accident. It maps onto the routes a single-use needle program actually covers:

  • 20–21G for viscous and depot medication
  • 22–23G for standard adult IM
  • 24–25G for thin IM and subcutaneous
  • 26–27G for intradermal and fine subcutaneous
  • 28–29G for fine subcutaneous and insulin syringes

For a distributor, that is one needle family covering four routes instead of four separate ranges; for a tender, it is fewer line items to qualify and fewer suppliers to audit. The trade-off is inventory breadth: ten gauges multiplied by the lengths each one is stocked in is a larger commitment than a five-gauge range, and the slowest-moving sizes are usually the two at the ends.

Safety Configuration Is a Separate Line on the Specification

WHO counts about 16 billion injections a year, roughly 90% of them therapeutic and given into muscle or skin. The same fact sheet puts the transmission risk from a needlestick with a needle used on an infected patient at 30% for hepatitis B, 1.8% for hepatitis C and 0.3% for HIV. WHO's 2015 guideline recommends safety-engineered syringes for all injections, with a mechanism that prevents reuse of the syringe and the needle.

That is why a safety syringe is specified as a separate line rather than as an upgrade to a standard one. Teamstand supplies retractable safety syringes and safety syringes with a retractable needle; both are ordered to the same 100,000-piece minimum as the standard line.

Be clear about the cost side before you quote. A safety mechanism adds parts and assembly steps, so the unit price is higher than a standard syringe; the retraction changes the feel of the plunger, which means training before a ward switches over; and a retractable device cannot be used for a procedure that needs the syringe to be refilled. None of that is a reason to avoid the category — it is the reason the specification has to say which mechanism, not just "safety".

What to Put on the Purchase Order

A needle order that names only the gauge will come back with a question, or with the wrong item. These are the fields to settle in writing:

  • Gauge and nominal outer diameter, both stated (for example 23G / 0.6 mm)
  • Length in millimetres and inches, because clinical protocols use both
  • Hub color, as a check rather than as the specification
  • Bevel type — regular, short, or intradermal
  • Connector — Luer lock or Luer slip, and the syringe nozzle it mates with
  • Safety configuration, if any, and which mechanism
  • Sterilization method and single-use marking
  • Packaging — individual peel pouch or bulk bag — and units per carton
  • Shelf life and the lot marking used for traceability
  • The documents you need for your own registration file

On that last point: ask which certificates and test reports the supplier can put in front of you, and check the scope against the product you are buying. A general statement that a supplier holds certifications is not evidence for a specific needle size, and it should not go into your tender response either.

Ordering: MOQ, Production and Lead Time

Both lines are made to order rather than shipped from stock, at a minimum of 100,000 pieces. For a buyer that changes three things:

  • The full shelf life is yours. Nothing has been sitting in a warehouse before it reaches you.
  • One order is one production batch, so the needles inside it are consistent in grind, coating and hub color.
  • Configuration is open at the point of ordering — gauge mix, length mix, packaging and safety mechanism can be set per order instead of taken from a stock list.

Lead time and price are quoted per specification; they are not fixed numbers we can publish, because both move with the gauge and length mix.

Frequently Asked Questions

What size needle is used for an IM injection?

22–25G for every age group, per CDC guidance. The length is what changes: 16 mm for a neonate into the vastus lateralis, 25 mm for an infant, 25–32 mm for a toddler, 16–25 mm for a child's deltoid, and 25–38 mm for adults depending on sex and weight. A wider 20–21G is used when the drug is viscous.

What size needle is used for a subcutaneous injection?

23–25G at 16 mm (5/8 inch) for all ages. The site is the fatty tissue over the triceps from 12 months up, or the thigh for infants under 12 months.

Is 21G bigger than 23G?

Yes. 21G is 0.8 mm outside diameter and 23G is 0.6 mm. The gauge number runs opposite to the bore — a higher number is a thinner needle.

What needle is used for an intradermal injection or a Mantoux test?

26G or 27G with a short bevel, 6–13 mm long, inserted bevel up at 5–15° to raise a 6–10 mm wheal with 0.1 mL of fluid.

Which gauge is used for insulin?

Insulin pens use their own 4 mm to 8 mm pen needles at 31–32G, which are outside the ISO 6009 color code. Insulin syringes take a hypodermic needle, and 29G is the finest size in the Teamstand 20G–29G range.

Do you supply safety syringes as well as standard ones?

Yes. Retractable safety syringes and safety syringes with a retractable needle are both available, at a minimum order of 100,000 pieces, made to order.

Next Step

If you are specifying a needle range for a tender, a distributor catalog or an OEM program, send the gauge and length mix you need with the target market, and we will confirm what can be produced against it. Start from the hypodermic injection syringe and disposable injection needle pages, or send the specification directly.

For the wider gauge-and-length background — including sizes outside this range — see the injection needle size guide. For winged infusion sets, the butterfly needle gauge chart and the scalp vein set size guide cover that family.

emma photo (1)

Author: EMMA

Marketing Manager

Hello, I'm Emma, serving as the Marketing Manager at Shanghai Teamstand Corporation. With over 10 years' experience in the medical industry. Our dedicated team is eager to offer you good service and high quality products with competitive price.

Mob: (00)86-18621901943
Email: sales@teamstandmed.com


Post time: Nov-18-2026